2-Channel IP55 Momentary / Toggle / Timer RF Receiver Module, 230Vac (Group 3)

The Cebek TL-602 is a 2-Channel 230Vac mains powered Momentary, Toggling/Latching or Timer RF relay receiver module supplied pre-built into an IP55 rated enclosure complete with external rod antenna.

Each relay output on this receiver board can be set individually to operate in the following modes:

• MOMENTARY MODE: Relay turns on only while the transmitter button is held down and turns off 1 second after button is released
• TOGGLING/LATCHING MODE: relay activates at the first push of the transmitter button and disconnects after a second push of the button
• TIMER MODE: relay activates for a user adjustable on-time of between 0.1 and 132 Seconds. Timer is a non-cumulative retriggerable type. Any further button presses made while the timer countdown is active will restore the full delay time (non-cumulative) without interrupting the relay. If no new triggers are received before the delay timeout is reached, the relay will turn off and the channel reset ready for a new trigger signal.

Reset Inputs: each channel has a reset input to immediately turn off (or disable) the corresponding relay output (all operating modes). Connect to volt-free contact closure like a switch, manual over-ride button, etc. All channels are disabled if any of the reset inputs remain closed.

From our Group 3 range of 433.92MHz RF remote control modules - mix and match from a variety of receiver and transmitter options to suit your needs (see compatibility table below). Up to 5 Group 3 transmitters can be learnt by a receiver. Other unlearnt transmitters within range will be ignored.